tack strip การใช้

• Removing the tack strips will leave small nail holes in the floor.
• Others proposed obstructions, such as fences, tack strips and barb wire.
• I removed the carpeting and tack strip, and plan to install resilient tile.
• Next, carefully pry up the tack strips while trying to avoid scratching the floor.
• In some cases, carpeting over a hardwood floor is installed with wooden tack strips along the edges.
• Q . A tack strip holding wall-to-wall carpeting left many holes in my concrete basement floor.
• The gap between the tack strip and the baseboard allows clearance to tuck the edges of carpet down and hide any irregularities.
• Wall-to-wall carpeting is held in place with tack strips nailed to the floor around the perimeter of the room.
• After the carpet has been removed and the tack strips are pulled up, wood putty then can be used to fill the holes.
• The tack strips are nailed down close to the baseboards with the tacks pointing toward the wall and away from the center of the room.
• A tack strip is a strip of wood about an inch wide with the pointed ends of tacks sticking up through it at a slight angle.
• The stretched carpet should be secured with tack strips that are nailed in place one-half inch away from the baseboard around the perimeter of the room.
• After the underlay is installed, the carpet is cut to fit, stretched over the area and firmly anchored to the edges of floor via the tack strips.
• Carpet installers attach the carpet to the tack strip on one side of the room then stretch the carpet and push it down onto the tack strip near the opposite wall.
• Carpet installers attach the carpet to the tack strip on one side of the room then stretch the carpet and push it down onto the tack strip near the opposite wall.
• The introduction of tack strip, " tackless strip ", " gripper strip ", or " smoothedge ", simplified the installation of wall-to-wall carpeting, increasing the neatness of the finish at the wall.
• Tack strip was invented by Roy Roberts in 1939 . This product revolutionized the power stretch method still used today for installing tufted carpet . " Gripper Edge " and " Smoothedge " were original trademarks made famous by Roy Roberts and his companies ..
• The strip has two functions : first, the tacks grip the carpet and permanently hold it in place and second, the carpet edge is jammed into the gap between the tack strip and the wall which gives it a finished look with little effort.
• Carpets can be produced on a loom quite similar to woven fabric, made using needle felts, knotted by hand ( in oriental rugs ), made with their pile injected into a backing material ( called tufting ), flatwoven, made by hooking wool or cotton through the meshes of a sturdy fabric or sewn together ) and fixed to a floor over a cushioned underlay ( pad ) using nails, tack strips ( known in the UK as gripper rods ), adhesives, or occasionally decorative metal stair rods.